Solar module sealant

Mainly used in places with high weather resistance requirements. The waterproof and moisture-proof properties of outdoor lighting fixtures and other outdoor products, the sealing of solar cell module frames, the sealing of solar lighting fixtures, and the sealing of solar cell module junction boxes play a role in adhesive sealing.  

Firstly, clean and dry the surface of the material to be adhered. Then, according to the amount used, cut off and seal the nozzle head. You can squeeze out the hose by hand or use a special syringe to squeeze it out. After use, pay attention to sealing the cap and ensure that the adhesive thickness does not exceed 6mm as much as possible. Avoid contact with eyes when applying adhesive. The complete curing time of this product is 8-12 hours.

Unused adhesive should be stored in a sealed manner to avoid exposure to rain and sunlight. The storage period is 6 months (below 25 ℃).

This product is non-toxic and non hazardous, but should not be ingested or seen.

Transportation: There are no regulations for domestic (CN-GB) or international (IMO, IATA, UN) transportation. Belonging to non dangerous goods.

performance index

Before curing: ① Appearance: white paste ② Product type: condensation type ③ Viscosity surface drying time (min, 25 ℃): 5-20 ④ Specific gravity: 1.50 ± 0.05

After curing: ① Elongation rate (%): 300-500 ② Tensile strength (MPa): ≥ 1.90 ③ Volume resistivity (Ω· cm): ≥ 1.0 × 1014

④ Dielectric strength (kV/mm): 18-22 ⑤ Adhesive strength (MPa): ≥ 1.90 ⑥ Hardness (JISA, 200 ℃): 45-50

CS-815 solar photovoltaic special sealant has the following characteristics:

This product is a single component organic silicon compound in the form of a white paste.

This product has good high and low temperature resistance, excellent UV aging resistance, ozone resistance, yellowing resistance, rain resistance, dirt resistance, hail impact resistance and other characteristics. After solidification, the colloid can be used over a wide temperature range.

Room temperature neutral curing, fast deep curing speed, no shrinkage during the curing process, with good waterproof, moisture-proof and insulation properties.

Compliant with the EU ROHS directive requirements