CS-875 Silicone Series

It is mainly composed of adhesive and thermal conductive particles. Before gluing, it is a paste like mixture, and after gluing, it solidifies under certain time and conditions. Our thermal conductive silicone is a single component room temperature vulcanized silicone rubber with good adhesive properties. Room temperature curing The curing conditions are simple Repackable, with a curing thickness generally between 4-5mm. But it is sensitive to the surface state of the heat sink, and the bonding strength of devices or heat sinks with surface contamination is weak. Strict on-site process control.

1. Environmentally friendly, non-toxic, non corrosive, in compliance with ROHS and REACH directives.

2. Excellent adhesion, fixation, insulation, sealing, moisture resistance, shock resistance, and aging resistance.

3. It can firmly adhere to different materials such as metal, glass, ceramics, plastics, etc.

4. The cured silicone rubber has good electrical insulation performance, high and low temperature resistance, waterproof and moisture-proof, aging resistance, and long-term rubber elasticity.

performance index

Before curing: ① Appearance: white semi flowing ② Product type: condensation type ③ Viscosity (mpa. s, 25 ℃): 30000-50000 ④ Relative specific gravity (25 ℃): 1.55 ± 0.05

Operational performance: ① Surface skinning time (min, 25 ℃): 10-30 ② Curing time (min, 25 ℃): 8-12 hours (3-5mm) ③ Curing time (min, 80 ℃)

After curing: ① Hardness (shore A): 55-65 ② Thermal conductivity [W (m · K): ≥ 0.6 ③ Dielectric strength (kV/mm): ≥ 15 ④ Dielectric constant (100MHz): 3.0

⑤ Volume resistivity (Ω· cm): ≥ 1.0 × 1015 ⑥ Tensile elongation at break (%): 120-150 ⑦ Operating temperature range (℃): 60 ℃ -200 ℃

⑥ Tangent value of dielectric loss (1MHz): ≤ 1.0 × 10-3 ⑦ Flame retardant grade

Clean the construction surface thoroughly, cut off the top of the nozzle according to the amount used, seal it on the packaging mouth, apply it to the construction surface, and place it in the air. The surface of this product will lose its stickiness (surface dryness) after 10-30 minutes at room temperature, and it will completely cure within 8-24 hours. Heating this product cannot significantly change its curing speed.

Unused adhesive should be stored in a sealed container. The storage period is 6 months (25 ℃).

This product is non hazardous, but should not be ingested or seen.

Transportation: There are no regulations for domestic (CN-GB) or international (IMO, IATA, UN) transportation. Belonging to non dangerous goods.

CS-875 single component room temperature cured silicone rubber has the following characteristics:

This product is a single component organic silicon compound, with a white semi flowing color.

This product has good high and low temperature resistance, earthquake resistance, corona resistance, anti leakage insulation, corrosion resistance, weather resistance and other characteristics. After solidification, the colloid can be used within a wide temperature range (-50~200 ℃).

During the curing process, it does not shrink and has good waterproof, moisture-proof, and insulating properties.

Compliant with the EU ROHS directive requirements.