Cs-811 special sealant for solar photovoltaic

It is mainly used for bonding and insulation of small household appliances such as induction cooker and rice cooker; waterproof and moisture-proof of outdoor products, sealing of solar cell module frame, sealing of solar lamp, junction box of solar cell module, playing the role of bonding and sealing.
* clean the surface to be constructed, cut off the top of the sharp mouth and seal it according to the dosage, install it on the packaging mouth, apply it on the construction surface, and put it in the air. The surface of the product can lose its adhesion (surface dry) within 10-30 minutes at room temperature, and fully cure within 8-24 hours. The heating of the product can not obviously change its curing speed.
* Unused rubber materials shall be sealed for storage. The storage period is 6 months (25 ℃).
* this product is not dangerous, but it is not allowed to enter or eyes.
* transportation: no domestic (cn-gb), International (IMO, IATA, UN) regulations. Non dangerous goods.
 

Before curing: ① external: black paste; ② product type: mixed type; ③ viscosity: surface dry time (min, 25 ℃): 5-20 & nbsp; ④ relative specific gravity: 1.50 & plusmn; 0.05
Operating performance: ① surface skinning time (min, 25 ℃): 10-30 & nbsp; ② curing time & nbsp; (min, 25 ℃): 8-12 hours (3-5mm) & nbsp; ③ curing time (min, 80 ℃)
After curing: ① hardness (Shore A): 40-50 & nbsp; ② tensile strength (MPA): & Ge; 1.90 & nbsp; ③ dielectric strength (kV / mm): & Ge; 15 & nbsp; ④ dielectric constant (100MHz): & le; 3.5
&Nbsp; & nbsp; & nbsp; & nbsp; & nbsp; & nbsp; ⑤ volume resistivity (& omega; & middot; cm): & Ge; 1.0 & times; 1014 & nbsp; ⑥ elongation at break (%): 400-700 & nbsp; ⑦ dielectric loss tangent (1MHz): & le; 2.0 & times; 10-3
&Nbsp; & nbsp; & nbsp; & nbsp; & nbsp; & nbsp; ⑧ service temperature range (℃): - 50 ℃ - 180 ℃ & nbsp; ⑨ flame retardant grade: 94v0

 

Cs-811 special sealant for electromagnetic furnace and solar photovoltaic has the following characteristics:
* this product is a single component organosilicon compound in black paste form.
* this product has good high and low temperature resistance, anti-seismic, anti corona, anti leakage insulation, corrosion resistance, weather resistance and other characteristics. After curing, the colloid can be used in a wide temperature range.
* no shrinkage during curing, good waterproof, moisture-proof and insulation performance.
* meet the requirements of EU ROHS directive & nbsp;