Cs-864 silicone rubber series

It is mainly used for fixing, damping, sealing and waterproof, bonding, insulation and other functions of electronic and electrical products. Such as white small household appliances, switching power supply, transformer, circuit board, network transformer, etc.
* clean the surface to be constructed, cut off the top of the sharp mouth and seal it according to the dosage, install it on the packaging mouth, apply it on the construction surface, and put it in the air. The surface of the product can lose its adhesion (surface dry) within 3-8 minutes at room temperature, and fully cure within 8-24 hours. The heating of the product can not obviously change its curing speed.
* Unused rubber materials shall be sealed for storage. The storage period is 6 months (25 ℃).
* this product is not dangerous, but it is not allowed to enter or eyes.
* transportation: no domestic (cn-gb), International (IMO, IATA, UN) regulations. Non dangerous goods.

performance index
Before curing: ① external view: white paste / no flow; ② product type: condensation type; ③ viscosity; MPa. S, 25 ℃) & nbsp; ④ relative specific gravity (25 ℃): 1.45 & plusmn; 0.05
Operation performance: ① surface skinning time (min, 25 ℃): 10-30 & nbsp; ② curing time & nbsp; (min, 25 ℃): 8-24 hours (3-5mm); ③ curing time (min, 80 ℃)
After curing: ① hard (Shore A): 40-50 & nbsp; ② thermal conductivity [& nbsp; w (M & middot; K): & Ge; 0.6 & nbsp; ③ dielectric strength (kV / mm): & Ge; 18-25 & nbsp; ④ dielectric constant (100MHz): 2.55
&Nbsp; & nbsp; & nbsp; & nbsp; & nbsp; & nbsp; ⑤ volume resistivity & nbsp; (& omega; & middot; cm): & Ge; 2.5 & times; 1014 & nbsp; ⑥ elongation at break (%): 130-170 & nbsp; & nbsp; ⑦ dissipation factor (100Hz): 0.0022
&Nbsp; & nbsp; & nbsp; & nbsp; & nbsp; & nbsp; ⑧ service temperature range (℃): - 50 ℃ - 200 ℃ & nbsp; ⑨ flame retardant grade
The above mechanical and electrical properties were measured at 25 ℃ and 75% relative humidity after curing for 7 days.

Cs-864 one component room temperature curing silicone rubber has the following characteristics:
* this product is a single component organosilicon compound, white paste.
* this product has good high and low temperature resistance, anti-seismic, anti corona, anti leakage insulation, corrosion resistance, weather resistance and other characteristics. After curing, the colloid can be used in a wide temperature range.
* no shrinkage during curing, good waterproof, moisture-proof and insulation performance.
* meet the requirements of EU ROHS directive.